Day: May 4, 2018

Using Node Red to Control the PCA9536

GPIO in minutes If you haven’t already, make sure to go through the setup tutorial. Once you’ve finished that we’re ready to go! The PCA9536 is an 8-pin CMOS device that provides 4 bits of General Purpose parallel Input/Output (GPIO) expansion through the I2C bus. We manufacture multiple mini-modules that utilize this chip, you can check them out here. If you haven’t already, get your devices plugged in, on a Raspberry Pi, that means installing the adapter, hooking up the I2C cable to the In port on the Relay Board, and powering the board. On any platform without native I2C,

Read More »

IoT Wireless Current Monitor Product Manual

Features Industrial Grade Wireless Current Monitor (RMS output) Range 0-100A Auto Time Delay based data sample transmission or on current change detection (configurable duration in both cases) Configurable Current change detection bounds Configurable Current Sensor Calibration over the wireless link 1-Mile Range with 2.4GHz or 2 Mile Range with 900MHz On-Board Antenna Superior LOS Range of up to 28 miles with 900MHz High-Gain Antennas Interface to Raspberry Pi, Microsoft Azure, Arduino and More Example Software for Visual Studio and LabVIEW Wireless Mesh Networking using DigiMesh® 256 Sensor Nodes per Network Open Communication Protocol for custom interfacing applications Small Form Factor

Read More »